 |
|
|
| |
 |
FLEXOSEAL is
a single pack water-based durable black or beige flexible
membrane
which is composed of a blend of a powerful water-based bitumen
and a dispersed liquid rubber compound, which have been carefully
formulated to produce a coating with some unique properties.
Once fully cured, the film can resist water penetration, even
when submerged.
FLEXOSEAL can be used to solve many problems,
including repairs to suspended verandahs (including the repair
of leaks between eg. balconies and exterior walls), sealing
retaining walls against penetration of moisture from the backfill,
water-proofing the exterior walls of subterranean cellars, workshops,
wine storage areas, etc.
COLOURS: Black, beige, plus a range of other
shades.
| SPECIAL FEATURES: |
| |
- Gives off no fumes
- Quick development of adhesion
- Water wash up (no solvents)
- Easy to roll on or brush
- Goes over any clean dry surface
|
 |
- Wide range of colours
- Early water resistance
- No toxic fumes or solvents
- Can be recoated at any time if required
- Non toxic in the dry state
|
|
| TYPICAL APPLICATIONS: |
| |
|
| THE PROBLEM:
Cracks in exterior wall/floor interface, allow
rain to leak through into the house. |
|
 |
|
| THE SOLUTION:
The area is masked out with tape and painted
with a thick coat of beige FLEXOSEAL.
A strip of FLEXOCLOTH is
cut and applied over wet surface and painted
over again. (see PRODUCT
INFORMATION SHEET) |
|
|
| Beige FLEXOSEAL
being used to seal leaking window frame. |
|
 |
|
| Black FLEXOSEAL used to protect concrete walls
of an Indonesian tapioca waste water tank. |
|
| Badly rusted and leaking gutter primed with METALFIX and
top coated with black FLEXOSEAL ( use strips of FLEXOCLOTH
for any joints and seams) |
|
 |
| A view of the tanks in series. The FLEXOSEAL protects the
slightly acidic waste water from attacking the concrete. |
|
|
| FLEXOSEAL can also be used to seal the interiors
of water tanks, and can renovate older tanks (also see METALFIX) |
|
 |
|
| Access hatchway of 600,000 litre water storage tank, lined with
FLEXOSEAL throughout. |
|
|
| View of the top area of the subterranean water storage tank,
before landscaping. FLEXOCLOTH strips were used over all joints
and seams. |
|
 |
|
| The FLEXOSEAL can be built up over the Flexocloth
base, to form a very tough, flexible, and durable membrane. The thickness of the
film can be varied, but is typically in the range 2mm to 3mm. The sheet widths
are from 200mm to 1.2 metres and the lengths are in a standard 10 metres |
|
|
| PHYSICAL PROPERTIES: |
| |
| Pot Life: |
Indefinite |
| Specific
Gravity: |
1.0 |
| Colour: |
Black, Beige |
| Pack Sizes: |
1 Litre, 4 Litre, 10 Litre |
| Dilution: |
Must not be diluted |
| Clean up: |
Water |
| Recoating
Times: |
Approx 4-6 hours (normal conditions, temperatures
above 25°C, sunlight, low humidity) |
| Coverage: |
2 coats of FLEXOSEAL are recommended.
First coat should be applied at approximately 1m2
per litre and a second coat at 2m2 per litre |
| PRODUCT
INFORMATION SHEET: |
| |
|
For your convenience we have provided as a download,
a PRODUCT INFORMATION SHEET in Adobe Acrobat format
below.
FLEXOSEAL.pdf
To view a PDF file you must have Adobe Acrobat
reader. It is free, and is available below.
Adobe Acrobat (4mb)
|
|
|
|
|
|